SD Card (1 GB) for use with the MotoSat SD Programming Module for upgrading software / firmware in Nomad 2/3 Television Controllers.

This SD Card works with the MotoSat Programming Module to update the software / firmware on the Nomad 2 or Nomad 3 Controllers.  This is a 1 GB SD Card that could also be used to store other data, photos, etc.

Instructions:
1. Download the latest software to this SD Card from http://www.motosat.com/downloads
2. Place the SD Card into the MotoSat Programming Module (sold separately)
3. Turn off the power to your Nomad 2 or Nomad 3 Controller
4. Plug the programming module into your Nomad 2 or Nomad 3 Controller
5. Turn on the power to your Nomad 2 or Nomad 3 Controller
6. Wait until the Programming Module LED Stops Flashing
7. Perform a Test Dish
You will now have the latest software version in your Nomad 2 or Nomad 3 Controller.  Write the software version down on the controller or somewhere for future reference.