MotoSat SD Programming Module for upgrading software / firmware in Nomad 2/3 Television Controllers.

This SD Programming Module is designed to allow loading of your new software into your Nomad 2 or Nomad 3 series controller by the use of an SD Card (sold separately) as a carrier.  It allows an SD Card to be loaded with new software from the http://www,motosat.com web site. The Nomad 2 and 3 series controllers use a 15pin D-Sub Connector for loading of new software,  The SD Card (sold separately) and the SD Programming module together make this conversion possible for a quick and easy way to upgrade software updates.

Instructions:
1. Download the latest software to an SD Card from http://www.motosat.com/downloads
2. Place the SD Card into the Programming Module
3. Turn off the power to your Nomad 2 or Nomad 3 Controller
4. Plug the programming module into your Nomad 2 or Nomad 3 Controller
5. Turn on the power to your Nomad 2 or Nomad 3 Controller
6. Wait until the Programming Module LED Stops Flashing
7. Perform a Test Dish
You will now have the latest software version in your Nomad 2 or Nomad 3 Controller.  Write the software version down on the controller or somewhere for future reference.